15350 Autoloader ALE: STEP : axis 1 communication error Trendsetter_400/800_Proofing Select RESUME from the workstation dialog box. If that doesn't correct the problem, then select RESET TRENDSETTER from the workstation TRENDSETTER pull-down menu. If the problem persists, call Creo service. Try cycling power on the machine. Check the SPI and TEE boards and replace them if necessary. If problem recurs, call proofer TTE. An error occurred while communicating with the VR stepper controller. A hardware fault likely caused this. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:03 2008 PST